Ana içeriğe geç

How to bleed 1986-1993 Volvo 240 brakes Girişe yapılan değişiklikler

Düzenleyen: David Hodson

Onay bekleniyor

Önce
Sonra
Değiştirilmemiş
Introduction
Bleeding brakes is a key part of automotive brake repairs. Whenever the brake lines are replaced or the brake fluid is drained, the lines must be bled to remove all air that may be present. A brake system with air in it is easy to diagnose, because the brake pedal inside the car will usually feel "spongey," and may go all the way to the floor when depressed.
The following procedure uses a Motive Power Bleeder, rather than a traditional manual bleeding. The Power Bleeder is significantly easier to use than other methods, and is not particularly expensive. (Note: iFixit is in no way affiliated with or supported by Motive. We just like their stuff!)
Imageid
Önce
Sonra
Conclusion
To reassemble your device, follow these instructions in reverse order.

Aletler

  • Socket 19mm x1 added.
  • 8 mm Open End Wrench x1 added.
  • Hydraulic Floor Jack x1 added.
  • Impact Wrench x1 added.
  • Jack Stand x4 added.
  • Motive Power Bleeder x1 added.

Parçalar

  • Brake Fluid DOT 3 or DOT 4 x1 At least 2 quarts added.