Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

3. Adımdaki Değişiklikler

Düzenleyen: Jake Devincenzi

Düzenleme onaylandı tarafından Jake Devincenzi

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] With the three screws removed, the driver will simply fold up to reveal the wiring. In this casecase, the color coded wirecode for the wires is Blue for left and Gold for ground.
[* blue] Here is the way I connected some alligator test leads. Use a male-male 3.5 mm stereo cable. Attach one lead to the sleeve, the upper part of the connector, and one lead to either tip (front) or Ring (middle) of the connector.
[* red] Attach some test points to the end of the alligator cables and touch the solder connections of the speaker (driver). In this case, there was clear sound. This determined that there was no signal cominggoing from the connector to the drivers.
[* black] With the three screws removed, the driver will simply fold up to reveal the wiring. In this casecase, the color coded wirecode for the wires is Blue for left and Gold for ground.
[* blue] Here is the way I connected some alligator test leads. Use a male-male 3.5 mm stereo cable. Attach one lead to the sleeve, the upper part of the connector, and one lead to either tip (front) or Ring (middle) of the connector.
[* red] Attach some test points to the end of the alligator cables and touch the solder connections of the speaker (driver). In this case, there was clear sound. This determined that there was no signal cominggoing from the connector to the drivers.