Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

4. Adımdaki Değişiklikler

Düzenleyen: Jake Devincenzi

Düzenleme onaylandı tarafından Jake Devincenzi

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Cut about 3 inch ofinches off the end of the cable.
[* red] To make sure that it was indeed the connector, and not a cracked wire further up, remove the insulation of one set of wires. The Lowriderdevice uses one set for each side. toTo remove the insulation, you can use a boxcutter, a sharp knife, or a lighterlighter, etc.
[* blue] Attach the test lead from any MP3 player, as previously shown. If the reason for the non-functioning headphones was the connector, there should now be sound oncoming from the headphone speaker (driver). In this case, there was. Therefore, it was indeed the audio connector that was broken.
[* black] Cut about 3 inch ofinches off the end of the cable.
[* red] To make sure that it was indeed the connector, and not a cracked wire further up, remove the insulation of one set of wires. The Lowriderdevice uses one set for each side. toTo remove the insulation, you can use a boxcutter, a sharp knife, or a lighterlighter, etc.
[* blue] Attach the test lead from any MP3 player, as previously shown. If the reason for the non-functioning headphones was the connector, there should now be sound oncoming from the headphone speaker (driver). In this case, there was. Therefore, it was indeed the audio connector that was broken.