Eşyalarını Tamir Et Topluluk Mağaza

10. Adımdaki Değişiklikler

Düzenleyen: Andrew Optimus Goldheart —

Düzenleme onaylandı tarafından Andrew Optimus Goldheart

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Remove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
[* orange] Three 2.7 mm standoff screws
[* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver.
- [* black] When you put the standoffs back in, you can easily get them started by inserting the tip of the spudger into the female threads
+ [* icon_reminder] Reassembly hint: when putting the standoffs back in, use the tip of a spudger like a screwdriver to get them started.