10. Adımdaki Değişiklikler
Düzenleyen: jsharris —
Düzenlenme reddedildi tarafından Geoff Wacker
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| [* black] Remove the following screws securing the logic board to the rear case: | |
| [* red] Two 2.3 mm Phillips screws | |
| [* orange] Two 2.7 mm standoff screws. | |
| - | [* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver. |
| + | [* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver. They are not phillips screws, the center hole is threaded. |
| [* yellow] One non-magnetic 2.7 mm standoff screw | |
| [* icon_note] Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass. | |
| [* icon_reminder] Reassembly hint: when putting the standoffs back in, use the tip of a spudger like a screwdriver to get them started. |