Ana içeriğe geç

7. Adımdaki Değişiklikler

Düzenleyen: Stefan Lewis

Düzenleme onaylandı tarafından Stefan Lewis

Silindi
Eklendi
Değiştirilmemiş

Adım Satırları

[title] Reassembling the Heater - Part II
[* light_blue] Make sure ONLY the larger plug is connected to the Circuit Board; we will connect the smaller one later to make it easier.
[* orange] Then make sure all the Spring are lined up correctly and seated in there spots.
[* violet] Press down on the Circuit Board until the board meets the cover and the Screw Holes are aligned with one another.
[* icon_note] Make sure that the springs are still in alignment.
[* red] Then with one hand, place your screws in and tighten them.
[* icon_caution] Be sure to stop the moment they get tight you don't want to crack the board.

Resim 2

Önceki resim yok

Eklendi