Eşyalarını Tamir Et Topluluk Mağaza

6. Adımdaki Değişiklikler

Düzenleyen: Anthony Kouttron —

Düzenleme onaylandı tarafından Anthony Kouttron

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Before I begin 3D modeling any part, I like to take the time to fully analyze the exterior construction and overall build of the item. The best way to do this is by looking at the seam lines, feeling around the part and looking for any imperfections.
-[* black] I chose to take a traditional approach and use a trusty pair of calipers, protractor and a set of drill bits. Ideally, one would use a radius gauge set and a pin gauge set, but those tools are quite pricey. The drill bits should suffice.
-[* black] This is not a terribly big part, but the funky geometry could lead someone to 3D scanning the part to ease in modeling.
+[* black] This is not a terribly big part, but the funky geometry could persuade someone to 3D scan the part for ease in modeling.
+[* black] I chose to take a traditional approach and use a trusty pair of calipers, protractor and a set of drill bits. Ideally, one would use a [http://www.starrett.com/metrology/product-detail/metrology/metrology-products/precision-measuring-tools/fixed-gage-standards/Radius-Gages/178A|radius gauge set] and a [http://www.starrett.com/metrology/product-detail/metrology/metrology-products/precision-measuring-tools/fixed-gage-standards/Pin-Gages/S4005-500|pin gauge set], but those tools are quite pricey. The drill bits should suffice.