Ana içeriğe geç

5. Adımdaki Değişiklikler

Düzenleyen: Anthony Kouttron

Düzenleme onaylandı tarafından Anthony Kouttron

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Before I started the modeling process, I decided to take a look at what could be contributing to the failure of thes LCD ribbon hinge caps.
-[* black] I picked up the camera and put it down a few times. I did this on a few surfaces. I noticed that this end cap naturally comes in contact with the table surface. Unless the camera is gracefully placed down after each use, there is no way this end cap would not become in contact with the supporting surface.
+[* black] I picked up the camera and put it down a few times. I repeated this on a few surfaces. I noticed that this end cap naturally comes in contact with the table surface. Unless the camera is gracefully placed down after each use, there is no way this end cap would not become in contact with the supporting surface.
[* black] Here is a very quick illustration of the camera placement process
[* black] One of my broken hinge caps was split down the middle, which also offered insight into the wall thickness of the cap at the face of contact.