16. Adımdaki Değişiklikler
Düzenleyen: Anthony Kouttron —
Düzenleme onaylandı tarafından Anthony Kouttron
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [* black] 6 parts were printed to serve as examples of minor design iterations of the part. This was intentional in case I made an error in measurement. Four additional prints were made as extras in case the parts were damaged during cleanup. |
|---|---|
| + | [* black] A good way to keep track of different part iterations is to engrave revision letters or numbers into the part printed. In this case, I embedded the label into the bottom of the cap where it would not be seen. |
| + | [* black] S = stepped geometry on cut 16 |
| + | [* black] W = Wider semicircle on cut 17 |
| + | [* black] N = Notched length on cut 11 |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi
Resim 3
Önceki resim yok
Eklendi