16. Adımdaki Değişiklikler
Düzenleyen: Anthony Kouttron —
Düzenleme onaylandı tarafından Anthony Kouttron
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| - | [* black] |
|---|---|
| + | [* black] Six parts were printed to serve as examples of minor part design iterations. This was intentional in case I made an error in measurement. Four additional prints were made as extras in case the parts were damaged during cleanup. |
| [* black] A good way to keep track of different part iterations is to engrave revision letters or numbers into the part printed. In this case, I embedded the label into the bottom of the cap where it would not be seen. | |
| [* black] S = stepped geometry on cut 16 | |
| [* black] W = Wider semicircle on cut 17 | |
| [* black] N = Notched length on cut 11 |