Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

3. Adımdaki Değişiklikler

Düzenleyen: Noah

Düzenleme onaylandı tarafından Noah

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Attach synchronizationSet the synchronization device toon the other carburetor.
[* red] Using a flatheadFlathead screw-driver, twist the idle speed screw in to raise the readingflow, and loosenout to lower itit.
[* black] The goal is the meet the two values halfway
[* black] So, if one is higher than the other, lower the high one,
Recheck both carburetors and raise the low on until they meet inadjust as needed to get the middleflow as equal as possible.
[* black] Attach synchronizationSet the synchronization device toon the other carburetor.
[* red] Using a flatheadFlathead screw-driver, twist the idle speed screw in to raise the readingflow, and loosenout to lower itit.
[* black] The goal is the meet the two values halfway
[* black] So, if one is higher than the other, lower the high one,
Recheck both carburetors and raise the low on until they meet inadjust as needed to get the middleflow as equal as possible.

Resim 1

Silindi