Ana içeriğe geç

7. Adımdaki Değişiklikler

Düzenleyen: Tobias Isakeit

Düzenleme onaylandı tarafından Tobias Isakeit

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[* black] While opening the display towards the bottom, using the display cables as a hinge, peel the adhesive off the display and the force touch gasket with a pair of tweezers.
+[* black] While opening the display towards the bottom at a 45° angle (to not put too much stress on the display cables) peel the adhesive off the display and the force touch gasket with a pair of tweezers.
+[* black] Thread the adhesive around and behind the display cables to get it off completely and press the gasket down to make it re-adhere to the case.
[* icon_note] If you are only replacing the force touch gasket you can continue [guide|113009|here|stepid=221634]. Otherwise keep on going :)
-[* black] Thread the adhesive around and behind the display cables to get it off completely.
- [* icon_reminder] Make sure you replace the adhesive ([product|IF308-002|38 mm|new_window=true] / [product|IF308-018|42 mm|new_window=true]) when reassembling the watch.
-[* black] Then press the gasket down to make it re-adhere to the case.
+[* icon_reminder] Make sure you replace the adhesive ([product|IF308-002|38 mm|new_window=true] / [product|IF308-018|42 mm|new_window=true]) when reassembling the watch.
[* icon_note] If the force touch gasket itself comes off the case too and it won't stick back down again you probably want to have two adhesives for reassembling the watch—one for underneath the gasket and one for between the gasket and the display.