Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

9. Adımdaki Değişiklikler

Düzenleyen: Justin

Düzenleme onaylandı tarafından Justin

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Remove the seat back mounting parts on the floor the vehicle.
[* black] This requires the use of the 10 mm triple square driver. Be sure to use a good one here.
[* black] I've tried a number of triple square drivers over the years, mostly with poor results. Good ones are expensive!
[* black] Here's a rather inexpensive triple square driver set (around $30): [http://www.amazon.com/8Pc-Triple-Square-4Mm-16Mm-Set/dp/B000I1Q60O|VIMXZN100 from Amazon]
[* black] I had a set from SK Tools that was very poor - the drivers were very loose when you put them in the bolt head you were trying to remove. They'd slip and strip the head of the bolt. Not recommended!
[* black] Please note that these bolts are extremely tight and difficult to remove. It's not that their just tight, they have lock-tight or something on them that make them hard to remove all together. They don't just "break loose".

Resim 1

Önceki resim yok

Eklendi

Resim 2

Önceki resim yok

Eklendi

Resim 3

Önceki resim yok

Eklendi