Ana içeriğe geç

4. Adımdaki Değişiklikler

Düzenleyen: Jeff Suovanen

Düzenleme onaylandı tarafından Jeff Suovanen

Önce
Sonra
Değiştirilmemiş

Adım Satırları

+[* black] Apply heat to the left edge of the iPad.
+ [* black] If necessary, re-heat your iOpener for a few seconds or until it's a bit too hot to touch. Be careful not to overheat the iOpener, or it may burst.
[* black] Insert a second opening pick at the bottom left corner of the iPad.
-[* icon_caution] Take especially care that you don't insert the opening between the actual display and the front glas panel.
-[* black] Slide the second opening pick down the left side of the display.
-[* black] Move the opening pick into the top left corner of the iPad where the headphone jack is located and leave it there.
+[* black] Slide the second opening pick along the left side of the display to separate the adhesive underneath.
+[* black] Leave the opening pick inserted near the top left corner of the iPad to prevent the adhesive from re-sealing.

Resim 1

Eski Sürüm

Yeni Sürüm

Resim 2

Eski Sürüm

Yeni Sürüm