Ana içeriğe geç

4. Adımdaki Değişiklikler

Düzenleyen: Jeff Suovanen

Düzenleme onaylandı tarafından Jeff Suovanen

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[* black] Apply heat to the left edge of the iPad.
+[* black] Apply heat to the left edge of the iPad for about two minutes, or until it's slightly too hot to touch comfortably.
[* black] If necessary, re-heat your iOpener for a few seconds or until it's a bit too hot to touch. Be careful not to overheat the iOpener, or it may burst.
[* black] Insert a second opening pick at the bottom left corner of the iPad.
[* black] Slide the second opening pick along the left side of the display to separate the adhesive underneath.
[* black] Leave the opening pick inserted near the top left corner of the iPad to prevent the adhesive from re-sealing.