Ana içeriğe geç

3. Adımdaki Değişiklikler

Düzenleyen: Arthur Shi

Düzenleme onaylandı tarafından Arthur Shi

Silindi
Eklendi
Değiştirilmemiş

Adım Satırları

[* black] Heat an iOpener and apply it to the same edge of the phone for two minutes.
[* black] Apply a suction cup to the back of the phone, as close to the center of the right edge as possible ([https://d3nevzfk7ii3be.cloudfront.net/igi/JlRhbQPyRWESV2Cr.full|where the adhesive is narrowest|new_window=true]).
[* black] Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame.
[* black] Insert the point of an opening pick into the gap.
[* icon_note] Due to tight tolerances, this may take multiple attempts.
[* black] If you are having trouble creating a gap, your best bet is to apply more heat to the edge and try the next stepprevious step again.
[* black] If you are having trouble creating a gap, your best bet is to apply more heat to the edge and try the next stepprevious step again.
[* black] You can try applying a few drops of high concentration (over 90%) isopropyl alcohol into the seam to help loosen the adhesive.
[* icon_caution] Do not apply excessive force with the pick, or you will risk cracking the back cover glass.