Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

5. Adımdaki Değişiklikler

Düzenleyen: Adam O'Camb

Düzenleme onaylandı tarafından Adam O'Camb

Silindi
Eklendi
Değiştirilmemiş

Adım Satırları

[* icon_note] If your part did not come with pre-cut adhesive, use high-bond double sided tape, or pieces of a [guide|113604|pre-cut adhesive sheet] to secure the camera bezel.
[*
black] Apply adhesiveCut pieces of tape to the appropriate size so they fit along the edges of the camera bezel.
[* icon_note] Measure the areas you want to apply tape to, and then mark those measurements on the tape with a pen to make sure each piece is the proper length and width. When in doubt, use a narrower size tape than you think you might need.
[* black] Use tweezers to apply the tape to the metal surface of the bezel, on the side where the camera lens cover protrudes.
[* black] Try to cover most of the metal surface of the bezel with tape. Avoid overlapping tape onto any plastic or glass areas.
[* icon_note] If your part did not come with pre-cut adhesive, use high-bond double sided tape, or pieces of a [guide|113604|pre-cut adhesive sheet] to secure the camera bezel.
[*
black] Apply adhesiveCut pieces of tape to the appropriate size so they fit along the edges of the camera bezel.
[* icon_note] Measure the areas you want to apply tape to, and then mark those measurements on the tape with a pen to make sure each piece is the proper length and width. When in doubt, use a narrower size tape than you think you might need.
[* black] Use tweezers to apply the tape to the metal surface of the bezel, on the side where the camera lens cover protrudes.
[* black] Try to cover most of the metal surface of the bezel with tape. Avoid overlapping tape onto any plastic or glass areas.