Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

2. Adımdaki Değişiklikler

Düzenleyen: Mike B

Düzenleme onaylandı tarafından Mike B

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[title] Body stripping
[* black] Remove top cap of sander. Carefully loosen motor brushesbrushes, they pop out by hand. Inspect for excessive wear (comingworn to coming close to spring).
[* black] During assembly, if the brush itself pops outhas popped out at any time, when refitting, make sure the curvature of the brush fits the rotor nicely to avoid excessive wear.
[* black] Remove top cap of sander. Carefully loosen motor brushesbrushes, they pop out by hand. Inspect for excessive wear (comingworn to coming close to spring).
[* black] During assembly, if the brush itself pops outhas popped out at any time, when refitting, make sure the curvature of the brush fits the rotor nicely to avoid excessive wear.
[* black] Remove the body by loosening the 4 torx screws in the base and carefully lifting the body off.
[* black] From now on you need to be careful and avoid damage to any of the wiring or contacts. So in the next phase, where you have to get rough, be careful!!