Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

3. Adımdaki Değişiklikler

Düzenleyen: Mike B

Düzenleme onaylandı tarafından Mike B

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[title] The hard part
[* black] YOuYou now have to separate the bottom plate from the body, but only enough to replace the dampnersdampers.
[* black] YOuYou now have to separate the bottom plate from the body, but only enough to replace the dampnersdampers.
[* black] Remember to keep all hard objects away from the rotor, damaging the wiring will make this tool a total loss.
[* black] First, I wedged some screwdrivers in between the two alu parts, the body and the sander plate. Little progress.
[* black] Then, I asked for an extra pair of hands and held the sanding plate by hand and someone else just smacked the !&&* out of the shaft, using a 8/9 mm pipe socket.
[* black] With thanks to my lovely assistant, Nikki.
[* black] IF you use a vice or similar, be careful to not break the plates. Put some wood in between??

[* black] I used something pipe shapeshaped, because I did not want to damage the threads on the center bolt, or hit on the bolt, and you need to avoid hitting the outterouter ring of the bearing, which is likely very tight. The pics somewhere in this guide should give some indication of where/what.
[* black] All you need is 1.5 cm, then you can turn the bottom plate, and it will expose the dampnersdampers.
[* black] Then, I asked for an extra pair of hands and held the sanding plate by hand and someone else just smacked the !&&* out of the shaft, using a 8/9 mm pipe socket.
[* black] With thanks to my lovely assistant, Nikki.
[* black] IF you use a vice or similar, be careful to not break the plates. Put some wood in between??

[* black] I used something pipe shapeshaped, because I did not want to damage the threads on the center bolt, or hit on the bolt, and you need to avoid hitting the outterouter ring of the bearing, which is likely very tight. The pics somewhere in this guide should give some indication of where/what.
[* black] All you need is 1.5 cm, then you can turn the bottom plate, and it will expose the dampnersdampers.