Drawer Roller Bracket Replacement 6 No'lu Adım Geçmişi

6. Adımdaki Değişiklikler

Düzenleyen: Austen Schram — 15 Mar 2020

Düzenleme onaylandı tarafından Austen Schram

-	[* black] Use drill with drill bit to make necessary holes for screws to sit and fasten the bracket. *I used a 3/36 inch drill bit*
-	[* black] The more screws used, the stronger the bracket is secured. My build required 12*#6x1/2inch screws*. This is 6 on each bracket, and three on end of the bracket.
-	[* black] If possible, use preexisting holes, and screws if possible. I would suggest three screws per end of the bracket. (Two on the bottom of the bracket, and one on the inside of the track.)
+	[* black] Use drill with drill bit to make necessary holes for screws to sit and fasten the bracket. Use drill bit slightly larger than shaft of screws, but smaller than the head of the screws.
+	[* icon_note] I used a 3/32 drill bit.
+	[* black] Install new fastener screws to the bracket.
+	[* icon_note] My build required 12 *#6x1/2inch philips screws*. I used three screws on each end of the brackets. 6 screws on each end of the bracket
+	[* icon_note] The more screws used, the stronger the bracket is secured. (Two on the bottom of the bracket, and one on the inside of the track.)
+	[* icon_note] If possible, use preexisting holes, and screws.
	[* icon_note] Sometimes screws protrude too far, you may have to grind the head of the screw slightly so it protrudes less.