Ana içeriğe geç

6. Adımdaki Değişiklikler

Düzenleyen: Andrew

Düzenleme onaylandı tarafından Andrew

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[* red] Once you have located the spool drive, stretch the v-shape part of the belt over it and place the platter back into its original place with the center gap aligning with the center .
-[* icon_note] If the step is done correctly, once the platter is spun, it will stop by itself.
+[* red] Once you have located the spool drive, stretch the v-shape belt over it and place the platter back into its original form that was shown in step 2.
+[* icon_note] If this step is done correctly, once the platter is spun, it will stop by itself.