Eşyalarını Tamir Et Topluluk Mağaza

9. Adımdaki Değişiklikler

Düzenleyen: Craig Lloyd —

Düzenleme onaylandı tarafından Craig Lloyd

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Slowly pull up to work the top case away from the bottom case.
- [* icon_note] Be extremely careful to make sure ***no internal components come out with the top case.*** However, there are bearings installed in the top case that ***may stay with the bottom half of the case.***
+ [* icon_note] Make sure ***no internal components come out with the top case.*** However, there are bearings installed in the top case that ***may stay with the bottom half of the case.***
[* black] Completely remove the top half of the transmission case. You may have to "walk" the top half of the case off of the shafts it is slotted through.
[* icon_reminder] Reinstallation tip: [https://d3nevzfk7ii3be.cloudfront.net/igi/SsUVytN1cYFZXPxF|Scrape off old gasket] before putting the transmission back together. Use a Scotch-Brite pad to remove any stubborn gasket from all mating surfaces, and do a final cleaning with isopropyl alcohol.
[* icon_caution] Be extra cautious to not let any old gasket fall into the transmission case oil basin, as debris could potentially harm future performance.
-[* icon_reminder] Reinstallation tip: When reapplying liquid gasket to the transmission case, [https://d3nevzfk7ii3be.cloudfront.net/igi/P22UOVo56mQtGBXC|run a 2-4 mm bead along all gasket mating surfaces] on both the left and right transmission cases. Use HondaBond 4, ThreeBond 1216 or an equivalent liquid gasket. Reassemble both transmission halves within 10 minutes of applying the liquid gasket.
-[* icon_reminder] Reinstallation tip: If necessary, use a mallet and lightly tap the right transmission case until mostly flush with the left transmission case when putting the two halves back together.
+[* icon_reminder] Reinstallation tip: When reapplying liquid gasket to the transmission case, [https://d3nevzfk7ii3be.cloudfront.net/igi/P22UOVo56mQtGBXC|run a 2-4 mm bead along all gasket mating surfaces] on both the left and right transmission cases. Use HondaBond 4, ThreeBond 1216, or an equivalent liquid gasket. Reassemble both transmission halves within 10 minutes of applying the liquid gasket.
+[* icon_reminder] Reinstallation tip: If necessary, use a mallet to lightly tap the right transmission case until mostly flush with the left transmission case when putting the two halves back together.