14. Adımdaki Değişiklikler
Düzenleyen: Arthur Shi —
Düzenleme onaylandı tarafından Arthur Shi
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| - | [* red] The strip you are about to install contains a microphone notch. This notch must be aligned over the iMac's microphone hole without covering it. |
|---|---|
| + | [* red] If you are installing adhesive on a 2015 and newer iMac, the microphone notch in the adhesive must be aligned over the iMac's microphone hole without covering it. |
| + | [* black] If your iMac does not have a microphone hole, align the right end of the strip such that the L-bend [https://d3nevzfk7ii3be.cloudfront.net/igi/1wctDT3SgQEG5VMZ.full|sits next to the right vertical adhesive|new_window=true].*** The L-bend should not overlap the right vertical adhesive. *** |
| [* black] Align the adhesive strip to the bottom edge by aligning the microphone notch to the microphone hole. | |
| [* orange] The microphone hole is [https://d3nevzfk7ii3be.cloudfront.net/igi/aLbbiARyWsfqjDAw.full|the center hole|new_window=true] surrounded by two other holes. | |
| [* icon_note] The adhesive tears easily. Be careful not to pull on the strip with too much force. | |
| [* black] Once you have aligned the strip, carefully set the left exposed edge onto the iMac to secure the alignment. |