Oculus Quest 2 Disassembly 2 No'lu Adım Geçmişi

2. Adımdaki Değişiklikler

Düzenleyen: VR Wizard — 10 Kas 2021

Düzenleme onaylandı tarafından Kyle Smith

	[title] Remove the rear cover
	[* red] One side at a time, insert a pick next to the nosepiece, slide it to the edge and pry.
	[* black] When both sides are loose, carefully lift the cover out.
	[* icon_caution] The proximity sensor is still connected, so be careful to not rip the flex cable.
-	[* black] Unlatch the clip and pull the flex cable out. It is lightly adhered to the headset.
+	[* black] Unlatch the small black clip which presses the cable against the contacts and then pull the flex cable out. It is lightly adhered to the headset.
+	[* black] When reassembling make sure to position the cable correctly. Than latching the small black clip back on should be possible without the need of much force. If you don't connect the cable correctly the screen of the Quest 2 will stay black and the headset will turn of after a few seconds.