Ana içeriğe geç

3. Adımdaki Değişiklikler

Düzenleyen: Philip Le Riche

Düzenleme onaylandı tarafından Philip Le Riche

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[title] Physical destruction: take aim!
-[* black] Take a look at your hard disk. From the lid, you should be able to make out the outline of where the disk is. Below that is the read/write head actuator. Note a point half way between the centre of the disk where you will be drilling a hole.
-[* black] If you have any difficulty working out where that is, or just want to see inside, you can unscrew the lid.
- [* black] You will generally need a Torx screwdriver. There are usually 6 screws around the perimeter of the drive. Remove these.
- [* black] Most laptop drives have one more screw under the label. You will need to locate it by feel, or by viewing it with the light at just the right angle.
- [* black] Scrape away the label from around the screw head, using a craft knife or similar. Under the label there is likeley to be a layer of foil. Scrape this away as well, revealing the screw head. Remove the screw.
- [* black] Desktop drives may have more screws, which you will have to locate and remove in the same way.
- [* black] Once you have remove all the screws you should be able to prise off the lid. A rubber seal may make it a little reluctant to come off.
+[title] Take aim!
+[* red] Take a look at your hard disk. From the lid, you should be able to make out the outline of where the disk is.
+[* orange] Below the disk is the read/write head actuator spindle.
+[* black] Note a point roughly half way between the centre of the disk and its circumference. This is where you will be doing the damage!

Resim 1

Önceki resim yok

Eklendi