Ana içeriğe geç

4. Adımdaki Değişiklikler

Düzenleyen: Adriana Zwink

Düzenleme onaylandı tarafından Adriana Zwink

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[title] Slice the adhesive
-[* black] Slide an opening pick underneath the connector of the fingerprint sensor to cut the adhesive underneath.
-[* black] Continue sliding the opening pick under the fingerprint sensor to cut through the adhesive underneath.
-[* black] Cut through the remaining adhesive until you can lift the sensor with the opening pick.
+[* black] Slide an opening pick underneath the top edge of the small board next to the fingerprint sensor.
+[* black] Use the opening pick to carefully cut the adhesive underneath the fingerprint board.
+[* black] Slide the opening pick underneath the fingerprint sensor to cut the remaining adhesive holding it in place.