1. Adımdaki Değişiklikler
Düzenleyen: Wayne Seltzer —
Düzenleme onaylandı tarafından Wayne Seltzer
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [title] Disassemble |
|---|---|
| + | [* black] Place the lamp horizontally on a work surface |
| + | [* black] Unscrew the two screws above the control panel that hold the upper and lower parts of the lamp together |
| + | [* black] Slide up the control panel to remove |
| + | [* black] Unscrew the two screws that hold the power board in place |
| + | [* black] Use a soldering iron to gently melt the two plastic studs that hold the touch sensor circuit board in place |
| + | [* black] Remove the touch sensor button. It's not really an electrical or mechanical button; it's just decorative. |
| + | [* black] Install a small fender washer, machine screw and nut. Drill a small hole in the center of the control panel where the touch sensor button is placed. |
| + | [* black] Drill out the bottom plastic stud for the touch sensor circuit board mount. |
Resim 1
Önceki resim yok
Eklendi