6. Adımdaki Değişiklikler
Düzenleyen: Wayne Roberts —
Düzenleme onaylandı tarafından Wayne Roberts
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [title] Removing the Vibration Motors And Screws From the Motherboard |
|---|---|
| + | [* black] The wires will need to be desoldered from the board, and will be replaced later for reassembly. |
| + | [* black] Note: each pair of wires has the black cable soldered to the lower connection; keep this in mind for the reassembly if the pictures from this guide aren't nearby. |
| + | [* black] Some of the solder in this controller requires a very high temperature to release. I had mine set to 450 C, however you may be able to remove it at a lower temperature. |
| + | [* black] Remove the two T-6 screws from the board near the vibration motors. |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi