2. Adımdaki Değişiklikler
Düzenleyen: esigourney —
Düzenleme onaylandı tarafından esigourney
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| - | [* black] To remove the circuit board detach the wires by desoldering them from the circuit board. |
|---|---|
| - | [* icon_caution] Do not over heat the solder and remove the wires slowly and carefully to not damage the circuit board. |
| + | [* black] Starting from the most accessible wire, desolder the wires from the circuit board one by one. |
| + | [* black] Make sure that the tip of the soldering iron is clean of all residue before starting. |
| + | [* black] Heat the soldering iron only to the temperature required to melt the solder. Check the specifications on your spool of solder for the correct temperature. |
| + | [* black] Be careful to touch the iron tip only to the solder. Do not touch the iron tip to the wire casings or any of the other elements on the board. |
| + | [* black] Once all of the wires have been desoldered from the circuit board, remove the circuit board completely from the drill. |