9. Adımdaki Değişiklikler
Düzenleyen: Arthur Shi —
Düzenleme onaylandı tarafından Arthur Shi
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| [* black] Lay a hot iOpener along the bottom left corner of the iPad, spanning from the opening pick to the home button. | |
| - | [* black] After letting the adhesive soften, insert a halberd spudger into the iPad next to the opening pick. |
| - | [* icon_note] An opening pick can be used in place of the halberd spudger. Use caution if using an opening pick, as inserting the pick too far can damage the display assembly. |
| - | [* black] Cut the adhesive along the bottom left side of the iPad using the halberd spudger. This may require reheating the edge of the iPad. |
| - | [* black] Continue to slide the halberd spudger back and forth to ensure most of the adhesive is separated. |
| + | [* black] After letting the adhesive soften, insert an opening pick or halberd spudger into the iPad next to the opening pick. |
| + | [* icon_caution] Be careful not to insert the opening pick deeper than 2 mm. |
| + | [* black] Slice the adhesive along the bottom left side of the iPad using the opening pick. If the slicing becomes difficult, reheat the edge and try again. |