Eşyalarını Tamir Et Topluluk Mağaza

11. Adımdaki Değişiklikler

Düzenleyen: Arthur Shi —

Düzenleme onaylandı tarafından Arthur Shi

Önce
Sonra
Değiştirilmemiş

Adım Satırları

-[* black] Lay a hot iOpener along the upper left corner of the iPad, spanning from the opening pick to the front-facing camera.
-[* black] After letting the adhesive soften, insert the blade of your halberd spudger into the iPad above the opening pick.
-[* black] Cut the adhesive along the upper left side of the iPad towards the front-facing camera using the halberd spudger. This may require reheating the edge of the iPad.
+[* black] Lay a hot iOpener along the upper left corner of the iPad, spanning from the opening pick to the front-facing camera. Wait a minute to let the adhesive soften.
+[* black] Use an opening pick to slice the adhesive along the upper left side of the iPad. If the slicing becomes difficult, reheat the edge and try again.
+ [* icon_caution] Be careful not to insert the opening pick deeper than 2 mm as you slice along the left edge.