3. Adımdaki Değişiklikler
Düzenleyen: AJ Pereira —
Düzenleme onaylandı tarafından AJ Pereira
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| [title] Mounting screw Pattern & Sliding on the Rail | |
| - | [* black] Follow the table for the recommended mounting locations and pre-install all the M3x8 SHCS screw and Sliding T-nuts |
| - | [* yellow] T-nut guide |
| - | [* red] The guide helps to slide the T-nuts into the extrusions |
| + | [* black] Follow the table for the recommended mounting locations |
| + | [* icon_note] Take note to skip 2 holes between fasteners, and make sure to mirror this process from each of the end of the rail until you meet in the middle. |
| + | [* black] Pre-install all the M3x8 SHCS screw and Sliding T-nuts |
| + | [* yellow] Install the Printed T-nut guide on the end of the X axis extrusion, and slide the rail on to the X-axis from Right to left |
| + | [* red] The guide helps to slide the T-nuts into the extrusion |