5. Adımdaki Değişiklikler
Düzenleyen: AJ Pereira —
Düzenleme onaylandı tarafından AJ Pereira
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| [title] X Carriage install | |
| [* light_blue] Belt adaptor | |
| [* green] 4x M3x8 SHCS | |
| [* orange] 3x M3 split washers | |
| [* red] M3 Hex nuts | |
| [* violet] Install the M3x8 SHCS screw with M3 Split washer in to the X carriage adaptor plate and mount to the Rail block. | |
| [* icon_note] Push up on the belt bracket, it is square against the bottom of the carriage block. | |
| - | [* yellow] HE Adaptor plate will Vary based on printer |
| + | [* icon_caution] Note: If screws will not start, threading in. Spin the screws counterclockwise until you hear a click, and then tighten the screws evenly in an X pattern until they are fully tightened. This is to ensure that the threads do not get damaged. |
| + | [* yellow] Note, reference Hotend Mounting Instructions section before mounting the MGN 12 Adaptor Plates to the linear rail block. For installing Hex Nuts to the back of the Adaptors. |