2. Adımdaki Değişiklikler
Düzenleyen: Ignacio Flores —
Düzenleme onaylandı tarafından Ignacio Flores
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [* black] Now, grab your ratchet and make sure the back of it is turned to ***loosen screws*** rather than tighten them. Each ratchet is different but they're all similar. |
|---|---|
| + | [* black] If you are not sure then go ahead and give it a few turns by hand and*** if there is noise being made when rotated up, that is tightening***. If that happens, then go ahead and turn the knob at the back to change this to loosening. |
| + | [* black] Once the ratchet is set up, go ahead and place it on one of the screws and start rotating the ratchet down then up to loosen each screw. You'll know you are doing it right if clicking noises happen when you rotate down and no noise is happening when you move up You're going to continue this motion until the screw is loose. |
| + | [* black] ***Note***: Make sure to hang on to each screw as they will be needed for the new mirror you will be placing on. Also, make sure that when loosening the last screw, to have someone or your free hand hang on to the mirror as it will become loose and probably fall down. |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi
Resim 3
Önceki resim yok
Eklendi