Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

5. Adımdaki Değişiklikler

Düzenleyen: Jeff Suovanen

Düzenleme onaylandı tarafından Jeff Suovanen

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* red] Removeicon_reminder] During reassembly, check the clicking action on the trackpad.
[* red] The
1.4 mm T5 Torx set screw from its tapped hole near the front edge of the upper case. (Removing this screw is NOT necessary to remove the trackpad)
[* icon_reminder] During reassembly, do not over-tighten the set screw, as
case must be adjusted correctly.
[* icon_note] If overtightened,
the button will cease to click at a certain point. Adjust the set screw until the clicking side of the trackpad has minimal play.
[* icon_note] It's not necessary to remove this screw in order to remove the trackpad.
[* red] Removeicon_reminder] During reassembly, check the clicking action on the trackpad.
[* red] The
1.4 mm T5 Torx set screw from its tapped hole near the front edge of the upper case. (Removing this screw is NOT necessary to remove the trackpad)
[* icon_reminder] During reassembly, do not over-tighten the set screw, as
case must be adjusted correctly.
[* icon_note] If overtightened,
the button will cease to click at a certain point. Adjust the set screw until the clicking side of the trackpad has minimal play.
[* icon_note] It's not necessary to remove this screw in order to remove the trackpad.