2. Adımdaki Değişiklikler
Düzenleyen: Maria Parker —
Düzenleme onaylandı tarafından Maria Parker
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [title] Trying to remove the circuit board |
|---|---|
| + | [* red] The circuit board is held down by two small Phillips screws. |
| + | [* black] Using a PH000 screwdriver, I remove them. They are pretty soft and the material wants to give in to the driver, but by pressing down firmly while turning the screwdriver I manage to remove them without damaging the heads too much. |
| + | [* black] The circuit board's corners are tucked under the case. More prying with my paper cutter gets the top two corners out. |
| + | [* black] I'm careful around the top because that's where the on/off switch is located, so there might be some cables there that I don't want to damage. I only pry close to the corners and avoid the centre of the top edge. |
| + | [* black] And I was right - when I manage to open the gap between circuit board and case further, there's the cable. |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi
Resim 3
Önceki resim yok
Eklendi