1. Adımdaki Değişiklikler
Düzenleyen: AJ Pereira —
Düzenleme onaylandı tarafından AJ Pereira
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [* icon_caution] After moving Z to 250mm above the bed and removing filament, Power Off, Power Cables ***UNPLUGGED!*** |
|---|---|
| + | [* icon_note] Remove printhead, DB15 cable, and control box and set aside. |
| + | [* icon_reminder] You will need access to the back of the machine as well as the front. Give yourself enough room to rotate the machine if not work all they way around. ***Another tip*** is to place a piece of cardboard on the build surface to use a place to work. |
| + | [* icon_note] If you have access to compressed air, blow the machine off. Use this time to clean the machine and give yourself good lighting to look over all the components thoroughly. |
| + | [* yellow] Using a 8mm open end wrench, loosen the bottom inner wheel eccentric locknut. Back it off a few turns. |
| + | [* green] Using a 7mm closed end wrench hold the nylock nut on the front of the X/Z bracket and loosen the eccentric wheel shaft with the M2.5 hex. |
| + | [* orange] Fully remove both lower inner wheels. They will not be used. |
| + | [* icon_note] 3 points is superior to 4 in this case. |