2. Adımdaki Değişiklikler
Düzenleyen: AJ Pereira —
Düzenleme onaylandı tarafından AJ Pereira
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [* black] The X Axis assembly is attached to the X/Z trolleys with 4 M4 cap screws and T nuts. |
|---|---|
| + | [* blue] Unplug the X End Stop then the X Motor (this can be done before or after X Axis removal depending on your access) |
| + | [* yellow] Remove the assembly by loosening the cap screws from the back of the machine. The T nuts just need to align parallel to the slot. |
| + | [* icon_note] Hold on to the X Axis assembly with one hand. If not, it will fall onto the bed. |
| + | [* violet] Be sure the X Motor is unplugged |