7. Adımdaki Değişiklikler
Düzenleyen: Philip Le Riche —
Düzenleme onaylandı tarafından Philip Le Riche
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [title] Bottom cover |
|---|---|
| + | [* red] Remove 4 screws in the cover beneath where the optical sensor was. |
| + | [* orange] Remove two screws at the inboard underside ends of the front arms. |
| + | [* black] Locate two screws retaining te front arms, accessible from dep within the bttery comparment. These have 2.5mm hex heads. Loosen them by a few turns only. You will most likely need a screwdriver extension, or a 2.5mm allen key. Don't remove them. |
| + | [* black] You should now be able to pull each of the front arms out by a millimetre or so. |
| + | [* black] You can now remove the bottom cover. Feed the ribbon cable back through the slot as you do so. |
| + | [* icon_note] On reassembly, don't forget to feed the ribbon cable back through the slot. |
Resim 1
Önceki resim yok
Eklendi