7. Adımdaki Değişiklikler
Düzenleyen: Philip Le Riche —
Düzenleme onaylandı tarafından Philip Le Riche
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| [title] Bottom cover | |
| [* red] Remove 4 screws in the cover beneath where the optical sensor was. | |
| [* orange] Remove two screws at the inboard underside ends of the front arms. | |
| [* yellow] Locate two screws retaining the front arms, accessible from deep within the bttery comparment. These have 2.5mm hex heads. Loosen them by a few turns only. You will most likely need a screwdriver extension, or a 2.5mm allen key. Don't remove them. | |
| - | [* black] You should now be able to pull each of the front arms out by a millimetre or so. |
| - | [* black] |
| + | [* black] You should now be able to pull each of the front arms out by a millimetre or so enabling you to remove the cover. |
| + | [* black] Feed the ribbon cable back through the slot in the cover as you remove it. |
| [* icon_note] On reassembly, don't forget to feed the ribbon cable back through the slot. |