6. Adımdaki Değişiklikler
Adım Satırları
| + | [title] Remove the rumble motors |
|---|---|
| + | [* black] The motherboard is held tightly to the black plastic midframe by plastic clips, and rumble motor wires are soldered to the motherboard on both sides. |
| + | [* light_blue] The blue circle is the plastic midframe piece holding the motherboard in place. |
| + | [* yellow] The yellow piece is a routing clip for the rumble motor wires. |
| + | [* black] The motors need to be moved to cleanly access the back of the motherboard, either by desoldering the motor wires, or softening the adhesive on the motors with isoprophyl alcohol. |
| + | [* icon_caution] Be careful not to damage the rumble wires on the routing clip or with the soldering iron. |
| + | [* black] Once the motor wires are removed, pry back the plastic pieces of the midframe on each end of the controller and pull up on the motherboard to remove it. |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi
Resim 3
Önceki resim yok
Eklendi