4. Adımdaki Değişiklikler
Düzenleyen: Alexander Collins —
Düzenleme onaylandı tarafından Alexander Collins
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| - | [* red] Loosen the two socket head screws holding the belt in. You do not need to fully remove these screws. |
|---|---|
| + | [* black] Orient the printer so that the screen is facing away from you. |
| + | [* red] Loosen the 2.5mm X 18mm and 2.5mm X 30mm socket head screws that hold the belt in. You do not need to remove these screws. |
| [* orange] Remove the belt from the belt grips by pulling the belt towards you. | |
| - | [* black] Un-feed the belt from its track. The belt should now be removed |
| - | [* yellow] During reassembly, ensure proper tension on the belt before reattaching |
| + | [* black] Un-feed the belt from its track. The belt should now be removed. |
| + | [* yellow] During reassembly, ensure proper tension on the belt before reattaching the back cover of the extruder assembly. With the extruder assembly positioned in the center of the X-axis rails, press the top of the belt with moderate pressure. The top of the belt should not be able to touch the bottom of the belt. |