3. Adımdaki Değişiklikler
Düzenleyen: William Cook —
Düzenleme onaylandı tarafından William Cook
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [* icon_note] Follow this step if the wires are still connected. If they aren't, skip to the next step. |
|---|---|
| + | [* black] Verify the integrity of the USB wiring to the circuit board. |
| + | [* black] If the wiring to the circuit board seems fine, use a razor or wire strippers to clear the rubber insulation away from the USB. |
| + | [* icon_caution] Keep track of the colors! If you connect the wrong wires together, the speaker won't work, and you could ruin the board! |
| + | [* black] After removing the rubber insulation from the smaller wires, remove the access USB. |
| + | [* black] Splice in the new USB and wrap the connection with the colored wires in electrical tape. |
| + | [* icon_note] If you end up with reduced sound quality, you may need to solder after all. Continue to the next step in that case. |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi