Bu Adımdaki Değişiklikler
Düzenleyen: Brendin Costa —
Düzenleme onaylandı tarafından Brendin Costa
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [* black] Once the solder is removed, use tweezers to carefully lift and remove the old button modules from the logic board. |
|---|---|
| + | [* black] Position the new SW2, SW3, and SW4 modules in place where the old ones were located. Make sure they are aligned correctly with the contacts on the logic board. |
| + | [* black] Secure the new buttons by resoldering them to the logic board. |
| + | [* icon_note] Apply a small amount of new solder to each contact point, ensuring a strong, clean connection. |