Bu Adımdaki Değişiklikler
Düzenleyen: Kristen Gismondi —
Düzenleme onaylandı tarafından Kristen Gismondi
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| - | [* black] Once the solder is removed, use tweezers to carefully lift and remove the old button modules from the logic board. |
|---|---|
| [* black] Position the new SW2, SW3, and SW4 modules in place where the old ones were located. Make sure they are aligned correctly with the contacts on the logic board. | |
| [* black] Secure the new buttons by resoldering them to the logic board. | |
| [* icon_note] Apply a small amount of new solder to each contact point, ensuring a strong, clean connection. |