3. Adımdaki Değişiklikler
Düzenleyen: Mice Principal —
Düzenleme onaylandı tarafından Mice Principal
- Önce
- Sonra
- Değiştirilmemiş
Adım Satırları
| + | [title] Removing Circuit Board. |
|---|---|
| + | [* black] Desolder the battery tabs and mask them off with electrical tape. You will need to use a fairly large soldering iron tip due to the side of the pads. You may well find you need to use an (ideally non-conductive) tool to lift the tabs clear. |
| + | [* black] Once all the tabs are clear, masked, carefully begin lifting the circuit board and the adhesive paper underneath as evenly as possible from all sides. Waggle it a little to begin to loosen it but not too much. |
| + | [* black] Take care whilst lifting as there are three thermistors going down amongst the cells from the board. and you do not want to damage them. |
| + | [* black] When the board is free, place it to one side. |
Resim 1
Önceki resim yok
Eklendi
Resim 2
Önceki resim yok
Eklendi