Eşyalarını Tamir Et Topluluk Mağaza

6. Adımdaki Değişiklikler

Düzenleyen: Doug —

Onay bekleniyor

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] Peel up the two pieces of foil tape on the left side of the keyboard area.
-[* icon_caution] The connectors at the ends of the cables are attached very firmly to the sockets on the logic board. Pulling directly on the cable will either separate the cable from its connector or the socket from the logic board.
-[* black] Carefully disconnect the microphone and power cables from the logic board. Using your fingernails or a dental pick, carefully pry the connectors from their sockets. Make sure you're pulling only on the connector and not on the socket.
+[* icon_caution] The connectors at the ends of the cables are attached very firmly to the sockets on the logic board. Pulling directly on the cable WILL BREAK SOMETHING; you will either separate the cable from its connector or the socket from the logic board.
+[* black] Carefully disconnect the microphone and power switch cables from the logic board. Using your fingernails or a dental pick, carefully pry the connectors from their sockets. You must not exert any force that pulls the socket away from the PCB. One method is to use two very thin screw drivers on opposite sides of the connector (similar to removing a paint can lid, but by twisting the screwdrivers at the same time).