Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

6. Adımdaki Değişiklikler

Düzenleyen: Matthew Newsom

Onay bekleniyor

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* blackred] Disconnect the dock connectordisplay cable from the rear casemain board by pullingflipping up the connector away from the socket.
[* black] Remove the battery.
[* icon_note] The display is now separate from the rest of the iPad.
[* black] Red: you flip a
pull tab, then pulland pulling the connector directly upward. yellow:use a spudger and pry gently upward. orange: use spudger/ipod
[* orange] Using an iPod
opening tool and firsttool, flip up both tabs (on the right side)tabs, then slide out the cablesLCD cables.
[* yellow] Using an iPod opening tool, remove the ambient light sensor connector from its socket by gently prying upward.
[* blackred] Disconnect the dock connectordisplay cable from the rear casemain board by pullingflipping up the connector away from the socket.
[* black] Remove the battery.
[* icon_note] The display is now separate from the rest of the iPad.
[* black] Red: you flip a
pull tab, then pulland pulling the connector directly upward. yellow:use a spudger and pry gently upward. orange: use spudger/ipod
[* orange] Using an iPod
opening tool and firsttool, flip up both tabs (on the right side)tabs, then slide out the cablesLCD cables.
[* yellow] Using an iPod opening tool, remove the ambient light sensor connector from its socket by gently prying upward.