Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

4. Adımdaki Değişiklikler

Düzenleyen: cityzen

Düzenleme onaylandı tarafından cityzen

Önce
Sonra
Değiştirilmemiş

Adım Satırları

[* black] The smaller of the two cables is for the touchpad. Lift the catch on its connector in order to slide it out.
[* black] The larger cable is for the key matrix. Just pull it out from the connector (friction fit).
[* black] This is as far as you can easily disassemble the keyboard. To go further requires undoingremoving 12 screws and 35 plastic "rivets" and 11 screwsrivets. This is not recommended, although you could use hot glue to redo the rivetsrecommended.
[* black] This is as far as you can easily disassemble the keyboard. To go further requires undoingremoving 12 screws and 35 plastic "rivets" and 11 screwsrivets. This is not recommended, although you could use hot glue to redo the rivetsrecommended.
[* black] To clean the keyboard of liquid, I suggest holding it over a sink with the touchpad side up, then spraying plenty of isopropyl alcohol from the back, avoiding the touch-pad area (you may wish to mask it off). Let dry completely before reassembling.
[* black] If keys still do not function after cleaning, then it is possible that traces on the key matrix have become corroded. In this case, itThis is necessary to completely disassemblenot repairable, since the keyboard and remove every key in order to expose the matrix sheet and fix any broken traces with conductive ink. This would beis a tremendous amountsealed unit. It consists of 3 layers of plastic that are sealed together. Unfortunately, it is not 100% sealed to prevent entry of workliquids.
[* black] If keys still do not function after cleaning, then it is possible that traces on the key matrix have become corroded. In this case, itThis is necessary to completely disassemblenot repairable, since the keyboard and remove every key in order to expose the matrix sheet and fix any broken traces with conductive ink. This would beis a tremendous amountsealed unit. It consists of 3 layers of plastic that are sealed together. Unfortunately, it is not 100% sealed to prevent entry of workliquids.