Ana içeriğe geç

8. Adımdaki Değişiklikler

Düzenleyen: iRobot

Onay bekleniyor

Önce
Sonra
Değiştirilmemiş

Adım Satırları

+[* icon_reminder] Important. When you reinstall a logic board, you'll need to replace the thermal paste that goes between the processor on the logic board and the heat sink. Failure to remove the old paste and apply a new layer can cause the computer to overheat and sustain damage. The following steps refer to replacing the thermal paste between the processor and heat sink; follow these steps only when you are ready to place the logic board in the computer.
+[* black] Use a firm plastic edge to scrape the thermal material off the raised copper heat conduit in three places. Clean the surface with rubbing alcohol.

Resim 1

Önceki resim yok

Eklendi